The Wakesurf Edge Wake Shaper attaches and detaches in seconds, without leaving a trace on your boat. It has super-strong, industrial strength, stainless suction cups which require no adhesives or modifications to your boat at all. Our suction cups are like no other out there - easy to install and uninstall, metal handles (not plastic clips that break and are hard to use), and are specially designed to handle some curvature on your boat's hull. Just attach the Wakesurf Edge Wake Shaper on the opposite side of the surfer towards the back of the boat, and surf away!
Easily stowable, the Wakesurf Edge Wake Shaper is also made in the USA, and made of non-corrosive, durable materials. It's ultra rugged, yet gentle on your gel coat. Plus, it floats! Other devices out there use common steel that rusts and heavy frames that sink, but the Wakesurf Edge Wake Shaper is completely non-corrosive and buoyant.
The Wakesurf Edge Wake Shaper is optimized to drastically improve the wake on most boats, and works great with evenly weighted ballast. It even further enhances the wave from boats with built-in surf tabs! It's compatible with most any boat that has a smooth finish. To see if your boat has a good attachment point, make sure the sides of your boat have at least a 6.5 inch by 14 inch smooth area near the stern. Does your hull have curvature? You may need to pick up our Curvature Adapter Rings.
Pushes water in a manner that increases the length of the wave and keeps it super clean!
NO NEED TO TETHER. Tethering could cause damage to your boat and your Wakesurf Edge Shaper. When properly attached, Wakesurf Edge Shaper will not come off, and it floats if dropped.
Easy to use… quick on/off… stronger than competition… won’t damage gel coat on your boat.
Copyright © 2018. All Rights Reserved